pural001

That seemed to do the trick (with the aid of a screw driver and some elbow grease). You guys were right about the rust. I was hoping it wouldn't be too bad, but it is fairly rusty inside. I think I will order a new line roller. thanks again.

Much appreciated. I'll give that a shot. Thanks.

Hi, I have noticed my Sol II 4000 acting up and making some loud noises while winding. Yep, you guessed it, line roller bearing is shot. I have opened it up and tried to give it a good clean but this has not helped. I have since purchased a replacement bearing however I am having issues removing the bearing from the line roller. Is there some kind of trick to this? I cannot seem to figure it out. My google searches didn't help either. Any help would be appreciated. Thanks.